(4) Adjustment of the knife (upper) and lower blade
meshing angle
Disassemble ⓐ~ⓔ parts in order then adjust them by
turning the setting screw Bⓕ. (Refer to the Figure 74)
Check that the setting screw Aⓖ is sticking out of the knife support bar base when
reassembling and insert into the hole of the knife holder shaftⓗ.
Caution
42
ⓗ
ⓖ
ⓕ
ⓑ
ⓒ
ⓐ
ⓔ
ⓓ
[ Figure 74 ]