Air-Compressed Device Installation - SunStar SC 7900-Series User Manual

Direct drive, 4-needle flat seamer feed off the arm type

Hide thumbs Also See for SC 7900-Series:

Table of Contents

8) AIR-COMPRESSED DEVICE INSTALLATION

(1) Specification

Table setting position

500

ⓖ

ⓐ

ⓕ

ⓔ

ⓑ

ⓓ

ⓒ

[ Figure 16 ]

① Connect the air hoseⓐ to the manifolder block of the filter regulator and solenoid valve.

② Connect the air hoseⓑ to the upper fitting of the air-compressed cylinder and the left side of the upper solenoid valve.

③ Connect the air hoseⓒ to the lower fitting of the air-compressed cylinder and the right side of the upper solenoid valve.

④ Connect the air hoseⓓ to the suction pipe and the lower solenoid valve.

⑤ Connect the cableⓕ which is written in 'PF' linking to the control box to the upper solenoid valve.

⑥ Connect the cableⓔ which is written in 'CL' linking to the control box to the lower solenoid valve.

⑦ After installing to the table, open the air-compressed regulatorⓖ of the filter regulator and set the compressed air at the

0.4~0.5 bar.

Table of Contents

Sc 7900-02 m6 a