Johnson Controls RA-3 Series Service And Data Information page 19

Electric Valve Actuators RA-3xxx-7x2x
General:
This Service and Data Information (in brief SDI) are
operating instructions and comprise the necessary
information for safe installation and operation of RA-3xxx-
7xxx electric valve-actuators. In the event of difficulties,
which cannot be resolved with the aid of this SDI, please
consult the supplier.
This SDI meets the requirements of the relevant safety
standards and regulations of the EU.
When operating valve-actuators outside of the Federal
Republic of Germany, it is the responsibility of the control
system administrator or operator to ensure that the valid
national control directives are followed.
The manufacturer reserves all rights in regard to
technical modifications and improvements at any time.
The SDI users qualifications are a prerequisite to their
application (See: "Qualified Personnel")
Operating personnel must receive SDI instructions.
Qualified personnel
These are persons conversant with the erection, installation, commissioning, operation and service of the
product and in possession of the respective qualifications through their activities and functions, e.g.:
•
Instruction about and obligation to maintain adherence to all operative regional / internal ordinances and
requirements, conditional to application.
•
Training or instruction in accordance with standards of safety in maintenance and utilisation of adequate
safety- and protective equipment.
• Training in first aid, etc. (See TRB 700).
Application:
RA-3xxx-7xxx electric valve-actuators are to be used in conjunction with the following valve series:
VG8000N, VG8000V, VG8000H, VG8300N, VG8300H, VG9000, VBF and VBD/VBB
Danger:
Safe operation of the valve is only ensured if the valve is installed, commissioned and
serviced by qualified personnel in compliance with warning references in this SDI. In
addition, the general installation- and safety regulations for pipelines, installation construction
and the professional use of tools and safety equipment must be guaranteed. Observe
unconditionally during all work on the control valve. Ignoring this information may cause
physical or material damages.
Storage:
• Storage temperature -40°C to 70°C, dry and free of dirt.
• Do not damage the lacquer. The lacquer is a foundation intended only as a protection against corrosion
while in storage and during transport.
• In rooms where moisture or condensation are present use heating or a drying agent to maintain moisture
free atmosphere.
© JCI Regelungstechnik GmbH
Westendhof 3 ♦ D-45143 Essen
Tel.: +49(0)201-2400-0 ♦ Fax: +49(0)201-2400-425
www.johnsoncontrols.com
(ERA1600, ERA1800, ERA3000)
SDI-No.: 111 6041 050 E
Issue Date: 08/2005