System Info; System Update; Maintenance Of Printer; (Optional) - MAHLE ACX120 Manual

EN | 29 | ACX120/220 | Maintenance
8. Install the new filter paying
attention to the position of
gaskets and to the direction
of the arrow indicating the
fluid flowing direction.
9. Screw the two connection
nuts of the filter.
10. Replace the front panel
11. Carry out the automatic leak
test
software when switched on
again
replacement.

14.12 System info

In the main menu select MAINTENANCE
and press "INFO".
In the INFO page, at any time, the
software version and the serial number
can be displayed.

14.13 System update

The firmware
updated by way of a USB stick.(where
the new version is stored)
1. Insert the USB stick in
USB port (fig.3 pos.4)
2. Power on ACX120/220.
3. In the main menu select
MAINTENANCE and
press "SYSTEM
UPDATE".
4. A message will appear
that the unit is loading an
update.
5. The unit may load an
updated language file and
configuration file while
updating.
6. Once unit is updated, the
software version string on
the introduction screen
© MAHLE
requested by
after the
(software) can

14.14 Maintenance of printer

To change the roll of paper follow
instructions below:
the
1.
filter
2.
be
3.
4.
during power up will
change

(optional)

Open the lid of the printer as
shown
.
Position the roll of paper inside
the housing in
direction indicated in the picture;
Pull the paper out of the housing
as indicated in the picture and
close the lid ;
The printer is ready for printing.
the rotation