Unit Mounting And Cooker Hood Wiring - SystemAir VTR 100/B LITE Installation And Service

16
| Installation
Tighten the screws in the bracket and on the wall (figure 15, pos. D). Lock the brackets into position using the locking
screws (figure 15, pos. E).
4.3.2.3 Optional installation in a cupboard with a base
1.
Using a saw, cut out a hole in the base of the cupboard. When the VTR 100/B LITE unit is mounted directly on the wall,
the minimum distance from the wall to the hole has to be 55 mm (figure 16, pos. A).
Note:
Be sure to add the thickness (dimension X) of your wooden blocks if they were used (figure 16, pos. B).
2. Attach the brackets as far into the cooker hood as pos-
sible. Insert the cooker hood up into the hole in the
base of the cupboard. Pull out (figure 17, pos. A) and
use screws to fasten the brackets to the sides of the
cupboard (figure 17, pos. B). Tighten the brackets in
the cooker hood.
4.3.3

Unit mounting and cooker hood wiring

Mounting the unit with attached cooker hood
1. Pull the cooker hood power supply and control cables to the top since the mounted VTR 100/B LITE unit will block ac-
cess to the back.
Fig. 16 Dimensions of a hole in the base of the cupboard
Fig. 17 Installation using brackets
212962 | v02