Unit Mounting And Cooker Hood Wiring - SystemAir VTR 100/B LITE Installation And Service

Follow instructions delivered with the cooker hood how to prepare it before installation.
1. Connect the cooker hood to the unit via a flexible duct. Use mounting mechanism which is delivered together with
the cooker hood (figure 9, pos. X).
4.2.3

Unit mounting and cooker hood wiring

1. Pull the cooker hood power supply and control cables to the top since the mounted VTR 100/B LITE unit will block ac-
cess to the back.
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
Warning
Beware of sharp edges during mounting and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely vertical and horizontal once mounted on the wall. Check with a spirit
level.
Make sure there is at least 2 mm gap between the unit and the cupboard to prevent vibration noises.
4.2.3.1 Wiring and configuration
1. Lead the cooker hood cables through a rubber grom-
met on top of the unit.
2. Connect control signal wires from the cooker hood to
digital input 2 (DI2) on the main board.
Note:
DI2 is pre-configured for cooker hood function.
Check and adjust airflow if necessary.
212962 | v02
Fig. 10 Placing the unit on the mounting bracket (the cooker hood is not shown)
11
Installation |