Climax LM5200 Operating Manual page 46

2. Remove the upper ram clamp block that is located in both of the following positions:
a. On the opposite side of the ram
from the milling head (see Figure
13 on page 44).
b. The upper clamp block, when the
ram is oriented vertically.
3. Attach the ram tether kit clamp block in
the position of the removed (upper) ram
clamp block. Use Table 3 for the
fasteners and minimum torque settings of
the clamp block for each model.
Table 3. Clamp block screw torque
values
Model Screw
Type
LM5200 M12
LM6200 M16
4. On the ram tether kit slide block, turn the
setscrew until it is flush with the block
inside surface (see Figure 14).
5. Install the slide block assembly on the
tether kit clamp block with the supplied
M16 hex head screw and washer so that
the setscrew will point up when the ram
of the linear mill is oriented vertically
(Figure 15). Leave the M16 hex head
screw loose in the clamp block hole.
6. Install the swivel base lifting eye in the
threaded hole on the side of the ram that
will be below the elevation of the tether kit
clamp block when the ram of the machine
is oriented vertically (Figure 15). Use
Table 4 for the torque settings of the
swivel base lifting eye for each model.
7. Select a tether chain length that will span
from the hoist ring to the chain support
plate.
Table 4. Swivel base lifting eye torque
values
Model
LM5200
LM6200
Page 44
Screw Torque
93 ft-lb (126 Nm)
230 ft-lb (312 Nm)
Swivel Base Lifting
Eye Torque
7 ft-lb (10 Nm)
20 ft-lb (27 Nm)
Figure 13. Upper ram clamp block removal
Figure 14. Slide block assembly
Figure 15. Slide block and swivel base
lifting eye installation
LM5200 Operating Manual