Secutron MR-2300 Series Installation And Operation Manual page 61

Command Menu-->MR-2300 Config
i
Note:
11.3.4 Opt Zone
I n d i c a t i n g Z o n e
1 N A C - 1
2 N A C - 2
3 N A C - 3
4 N A C - 4
This menu is used to program the process type of the indicating circuits. The maximum
number of indicating circuits is four, but only those supported by the particular model will be
shown.
Command Menu/MR-2300 Config/Opt. Zone
1. Type (Indicating Circuits)
NAC-1 Type
[X] SIL-ABLE
4.
NAC-4 Type
[X] SIL-ABLE
Command Menu-->MR-2300 Config
11.3.5 Correlation
Command Menu/MR-2300 Config/Correlation
1.Correlation
Z o n e - 1 C o r r .
[ X ] N A C - 1
12.
Z o n e - 1 2 C o r r .
[ X ] N A C - 1
Refer to section 11.2.1 on page 55 for detailed instructions on making menu
selections.
[X] SIL-ABLE->Default
[ ] NON SIL-ABLE
[ ] SIL-ABLE STR
[ ] NON-SIL STR
[X] NAC-1 ->Default
[X] NAC-2 ->Default
[X] NAC-3 ->Default
[X] NAC-4 ->Default
Use this menu to select the
process type of each
indicating circuit. See
section 9.4 on page 46
for
details.
Use this menu to correlate
initiating circuits to the
indicating circuits. By default
all the initiating circuits are
correlated to all the indicating
circuits.
Configuration
61