Figure 39 I3 Loop Test Confirmation; Figure 40 I3 Test Zones; Figure 41 I3 Test Not Ready; Figure 42 The Selected Zone Is Not I3 Type - Secutron MR-2300 Series Installation And Operation Manual

inquiries. An i
just been powered up or reset, wait six minutes before selecting the i
test is selected, the following message appears on the screen:
Figure 39 i
If you select "yes" by pressing "ENTER", the display will ask you for which zone you want to
perform the i
zone by pressing the "UP" and "DOWN" keys and then pressing the "RIGHT" key to select the
device. After the device is selected press "ENTER".
Figure 40 i
3
If the i maintenance test is selected within six minutes after power-up or reset, the following
information message is displayed.
Figure 41 i
If a zone is selected that is not configured as an i
Figure 42 The selected zone is not i
Once the zone goes into the i
maintenance test will take five minutes. During this time you can walk through the device and
make sure all the devices are working properly. The following table lists the status of the
devices while in loop test.
i
Note:
3
Table 10 i Detector LEDs while in test mode
3
i Detector Condition
Proper operation
Out of sensitivity
3
maintenance test can be invoked from the command menu. If the fire alarm has
P e r f o r m t h e i 3
L o o p t e s t ? Y
3
loop test confirmation
3
test. Note that only one zone at a time can be in maintenance test. Select the
- I 3 T E S T Z O N E S -
[ ] Z o n e - 1
3
test zones
T h e s e l e c t e d z o n e
i s n o t r e a d y y e t
3
test not ready
T h e s e l e c t e d z o n e
i s n o t i 3 t y p e
3
loop test, no other zone can be put into the test. The
Out of sensitivity can mean the device is dirty.
Green LED
Double blink every 5 sec
OFF
3
zone, the following message is displayed:
3
type
Red LED
OFF
Double blink every 5 sec
Configuration
3 3
loop test. If the i loop
69