Secutron MR-2300 Series Installation And Operation Manual page 51

3
10.3.1 i zone Troubles
The following troubles can be reported for a zone configured as i
• Open circuit trouble
• Communication trouble
• Out of sensitivity: defective or dirty device
• Freeze trouble
10.3.2 Open circuit trouble
If the loop is broken the panel shows open loop trouble. The panel can still communicate with
the devices depending upon where the open occurs.
Z o n e - 1
O p e n T r b .
10.3.3 Communication Trouble
If there is a fault in the line or the line is too noisy, the panel cannot communicate with the
devices. The panel shows a communication trouble in this case.
Z o n e - 1
C o m m u n i c . T r b
10.3.4 Dirty Device trouble
If any of the devices on the i
device needs cleaning or be replaced with a new device.
Z o n e - 1
D i r t y D e v . T r b
10.3.5 Out of sensitivity trouble
If any of the devices on the i
the panel shows out of sensitivity trouble. In this condition the device is not usable and should
be replaced.
Z o n e - 1
O u t o f S e n s T r b 1 / 1
1 / 1
1 / 1
3
zone are dirty, the panel shows a Dirty Device trouble. The
1 / 1
3
zone is out of sensitivity and cannot detect an alarm condition,
Supported Protocols/Devices
3
zone:
51