Uninstalling A Dw6000 Or Dw7000 - Hughes HN7000S Manual

Uninstalling a DW6000
or DW7000
7. Label the cable with a tag or small piece of electrical tape
with the words satellite out written on it.
8. Remove the two 25-pin connectors from the two modems.
9. Remove the USB cable from the IRU.
10. Dispose of the DW4000 remote terminal. See Disposing of
the old remote terminal on page 2 for information on disposal
and recycling. Do not return the remote terminal to Hughes.
You may discard the modems, USB cable, power supply, and
25-pin cable; you are not required to return them.
11. Proceed to Chapter 3 – Installing the HN7000S remote
terminal.
Complete the procedures in this section if you are upgrading from
a DW6000/DW7000 remote terminal. Complete the following
steps, referring to Figure 3:
1. Turn your computer off.
2. Unplug the power supply from the wall outlet or other power
source.
3. Unplug the power supply's DC power cord from the
DW6000/DW7000 remote terminal. Set the power supply and
cords aside.
CAUTION
• When removing power from the DW6000/DW7000
remote terminal, always unplug the AC power cord from
the wall outlet, surge protector, or power strip first.
• Never pull the DC power cord from the back of the
remote terminal until the AC power cord is
disconnected. Doing so could damage the pins and
cause a short in the system.
4. Locate the Ethernet cable that connects the
DW6000/DW7000 remote terminal to your computer and
detach it from the remote terminal. Leave the other end of the
cable attached to your computer; you will reuse it.
Chapter 2 • Uninstalling your current remote terminal
1037076-0001 Revision C
7