Conformance With Standards And Directives; Safety - Operating Conditions For Canada - Hughes HN7000S Manual

Conformance with standards and
Safety – operating
conditions for Canada
The HN7000S remote terminal has been certified to conform to
the standards shown in Table 1. Additional information follows
the table.
Table 1: HN7000S standards compliance
Category
Safety
Electromagnetic
Interference (EMI)
Electromagnetic
Compatibility (EMC)
Telecommunications
In addition to the warnings and safety guidelines listed in this
document, the following operating conditions apply to the
HN7000S remote terminal used in Canada:
The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment
meets certain telecommunications network protective operational
and safety requirements. The Department does not guarantee that
the equipment will operate to the user's satisfaction.
Before installing the equipment, users should make sure they are
permitted to connect to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord).
Appendix B • Conformance with standards and directives
Appendix B
directives
Standard
UL60950-1 for the United States
CAN/CSA-C22.2 No. 60950-1
for Canada
(see additional information below)
EN60950-1 for the European Union
FCC Part 15 for the United States
(see additional information below)
ICES-003 for Canada
EN301-489-12 for the European
Union
TIA IPoS
(see additional information below)
1037076-0001 Revision C
71