09 | Keysight | Making Bipolar Transistor Characterization using SMU - Demo Guide
to show Sweep Sub-Panel.
9) Press
10) Press
, then press
turning on the Single Linear Sweep Mode, you can see the Source Shape which
shows the single linear sweep mode.
11) Rotate
to select the Channel 2 Sweep Parameters and set them up as below.
(Start: 0 V, Stop: 0.85 V, Points: 86, Step: 10 mV)
5. Change the View mode to Graph View
1) Press
repeatedly until Graph View
is displayed.
6. Perform the measurement
1) Press Ch1 and Ch2
2) Press
to perform a sweep measurement.
(The status information will show
to turn on the Single Linear Sweep Mode. After
to turn on both Channel Output relays.
during the measurement.)