Specialized LEVO SL Series User Manual page 27

GENERAL TORQUE SPECS:
LOCATION
SEAT COLLAR
STEM @ STEERER TUBE
STEM @ HANDLEBAR
CRANK BOLTS
CHAINRING BOLTS
SPIDER BOLT
WATER BOTTLE BOSS
12 mm REAR AXLE
DERAILLEUR HANGER
CARBON FRAME - HEAD TUBE EXIT PORT (mounting
screw)
ALLOY FRAME - HEAD TUBE EXIT PORT (mounting
screw)
BATTERY MOUNT
TCU DISPLAY
MOTOR MOUNTS DRIVE SIDE
MOTOR MOUNTS NON DRIVE SIDE
MOTOR COVER
CHAINSTAY MOUNTED SPEED SENSOR
SPEED SENSOR MAGNET (6 BOLT VERSION)
REMOTE
BUMP STOP (depending on frame size)
The seat collar torque spec can vary depending on the seatpost or seatpost/shim combination.
3
Certain dropper seatposts can be very sensitive to torque. Too low torque can cause seatpost
slip, too high torque can cause the mechanism to bind as the saddle is raised or lowered. The seat
collar baseline torque spec is 45 in-lbf / 5.1 Nm, but can be raised or lowered slightly (35-55 in-lbf
/ 4.0-6.2 Nm) as required by the seatpost. Follow the seatpost's recommended applied torque if
available, and do not exceed 55 in-lbf / 6.2 Nm.
Apply blue loctite to chainring bolts.
4
CAUTION (non-pivot bolts): Ensure all contact surfaces are clean and greased.
PIVOT TORQUE SPECS (Torque the pivot bolts in the order listed below, after the assembly is complete):
LOCATION
MAIN (BOTTOM BRACKET)
LINK @ SEAT TUBE
LINK @ SEATSTAY
DROPOUT (HORST LINK)
LINK @ EXTENSION
UPPER SHOCK EYE
25
TOOL TORQUE (Nm)
4 mm HEX
4 mm HEX
4 mm HEX
8 mm HEX
5 mm HEX
4 mm HEX
3 mm HEX
6 mm HEX
2.5 mm HEX
2 mm HEX
2 mm HEX
T25 TORX
T10 TORX
T30 TORX
T30 TORX
T25 TORX
2.5 mm HEX
T25 TORX
2 mm HEX
T25 TORX
TOOL TORQUE (Nm)
6MM HEX 24
6MM HEX 20.3
6MM HEX 20.3
6MM HEX 20.3
6MM HEX 20.3
6MM HEX 10.2
TORQUE (in-lbf)
6.2 55
3 3
5 44
5 44
50 443
10 89
4 4
5 44
2.8 25
15 133
0.8 7
0.8 7
0.8 7
3 27
0.8 7
17 150
10 89
2.5 22
1 9
6.2 55
0.8 7
3 26.55
(in-lbf)
TORQUE
160
180
180
180
180
90