Table of Contents
Advertisement
Dust.Collection
The W1829 has a built-in dust collection fan and chip
exhaust. It also includes a 2.5" dust port, clamp, and dust
collection bag. The W1829 can also be hooked up to a
pre-existing dust collection system.
Recommended.CFM.at.Dust.Port:................. 150.CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection "how-to" book.
To install dust port and collection bag, do these steps:
1. Install the dust port to the chip exhaust, as shown in
Figure 16.
2. Slip the bag clamp over the collection bag, then
attach the collection bag to the dust port and clamp
it in place, as shown in Figure 17.
This. machine. creates. substantial. amounts. of. dust.
during.operation..Breathing.airborne.dust.on.a.regu-
lar.basis.can.result.in.permanent.respiratory.illness..
Reduce.your.risk.by.wearing.a.respirator.and.captur-
ing.the.dust.with.a.dust.collection.system.
Recommended.
Adjustments
For your convenience, the adjustments listed below have
been performed at the factory and no further setup is
required to operate your machine.
However, because of the many variables involved with
shipping, we recommend that you at least verify the
following adjustments to ensure the best possible results
from your new machine.
Step-by-step instructions for these adjustments can be
found in Service on Page 30.
Model W1829 (Mfd. Since 2/20)
Figure 16. Installing the dust port.
Figure 17. Attaching the dust collection
1. Knife settings (see Page 32).
2. Fence stop accuracy (see Page 35).
-18-
bag.
Advertisement
Table of Contents
