Table of Contents
Advertisement
Assembly
Before beginning the assembly process, refer to Items.
Needed.for.Setup and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the Test.Run.or connecting
the machine to power.
To assemble the jointer, do these steps:
1. Use two M8-1.25 x 20 cap screws and 8mm lock
washers to attach fence support to jointer bed, as
shown in Figure 9.
2. Insert the locking plate assembly into the fence
support, positioning it so the two pins are against
the bottom edge of the fence support, as shown in
Figure 10.
3. Secure the locking plate in position with the fence
sliding handle, as shown in Figure 11.
4. Use the remaining four M8-1.25 x 20 cap screws and
8mm lock washers to attach the fence to the fence
bracket assembly, as shown in Figure 12.
Model W1829 (Mfd. Since 2/20)
Figure 9. Attaching the fence support.
Locking Plate
Assembly
Locking
Plate Pins
Figure 10. Inserting the locking plate.
Locking Plate
Assembly
Figure 11. Installing fence sliding handle.
Bracket
Assembly
Figure 12. Attaching the fence bracket
assembly to the fence.
-16-
Cap Screws
Fence
Support
Fence Sliding
Handle
Fence
Cap
Screws
Advertisement
Table of Contents
