Inventory - Woodstock SHOP FOX W1829 Owner's Manual

Model W1829 (Mfd. Since 2/20)

Inventory

The following is a description of the main components
shipped with the Model W1829. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Inventory (Figures 4–5)
A. Jointer Bed Assembly .....................................1
B. Fence ........................................................1
C. Dust Collection Bag .......................................1
D. Limit Block .................................................1
E. Push Blocks .................................................2
F. Fence Tilting Handle ......................................1
G. Fence Bracket Assembly ..................................1
H. T-Handle Torx Driver T-30 ................................1
I.
Fence Sliding Handle ......................................1
J.
Fence Support ..............................................1
K. Locking Plate Assembly ...................................1
L. Dust Chute ..................................................1
M. Dust Collection Bag Clamp ...............................1
N. T-Handle Hex Wrench 4mm ..............................1
O. Hex Wrench 6mm ..........................................1
P.
Hex Wrench 5mm ..........................................1
Hardware and Tools (Not shown)
—Cap Screws M8-1.25 x 20 ...............................2
—Lock Washers 8mm ......................................2
—Cap Screws M6-1 x 20 ...................................2
—Lock Washers 6mm ......................................2
Qty
Figure.4. Large components.
P
O
N
M
K
L
J
Figure.5. Small components.
-13-
A
B
C
D
E
G
H
I
F