Table of Contents
Advertisement
While the main components of the Shop Fox
some assembly is required. The following is the recommended sequence best suited for final assembly.
TOOLS REQUIRED: You will need a 10mm, 12mm and 14mm open end wrench, a flat tipped screwdriv-
®
er, a Phillips
screwdriver (not supplied) and a 3mm, 4mm and 5mm Allen
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Figure 7. Using holes in base as drill guide.
Figure 8. Installing the dust port.
ASSEMBLY
®
W1668 Oscillating Drill Press are assembled at the factory,
1. Ensure machine is unplugged before begin-
ning assembly!
2. Place base on a stable work bench. Make
sure the work bench will handle the weight
of the drill press and workpiece.
3. It is recommended that the base be secured
to the bench. Otherwise a tipping hazard
will exist.
4. Clamp the base to the table once a suitable
location is found. Use
through bolts with washers, lock washers
and nuts. Use the mounting holes in the
base as a drill guide. Figure 7.
5. Place the column on the base and line up
the 4 mounting holes. Secure tightly with
the M10-1.5 x 25mm hex head bolts using
open end wrench provided.
The two-piece dust port is assembled to the bot-
tom of the table using the four M4- 0.7 x 22mm
®
Phillip
-
-
9
®
wrench (supplied).
Base/Column
Do
not
machine to power at this
time. The drill press must
remain unplugged through-
out the entire assembly
process. Failure to do this
may result in serious per-
sonal injury.
5
⁄
Dust Port
head screws. Figure 8.
connect
the
" lag bolts or
16
Advertisement
Table of Contents
