Woodstock SHOP FOX W1829 Owner's Manual page 39

Model W1829 (Mfd. Since 2/20)
Setting 45° Outward Stop
1. DISCONNECT JOINTER FROM POWER!
2. Loosen the fence tilting handle, remove the limit
block and set it aside.
3. Tilt the fence backward (away from the table) until
it stops.
Note: The fence will stop when the outward stop
bolts hit the fence bracket.
4. Use a square to check the angle of the fence, as
shown in Figure 45.
— If the fence is tilting away from the table at 45º,
the outward stops are set correctly. Put the limit
block back, bring the fence to 90°, and tighten
the tilting handle.
— If the fence is not tilting away from the table at
45º, perform Steps 5–6 to set the outward stops
correctly.
5. With the outward stop bolts resting against the fence
bracket, use an 8mm wrench to adjust the length of
the stops until the fence is at 45º, then tighten the
jam nuts (see Figure 46).
6. Put the limit block back, bring the fence to 90º, and
tighten the fence tilting handle.
Figure 45. Checking the outward 45º stop.
Jam Nut
Figure 46. Outward stop bolt detail.
-37-
Outward
Stop Bolts