Table of Contents
Advertisement
After one of the device is chosen, the device on the topology diagram shows the SN and IP
address of the chosen one.
4. Choose board type of In and Out according to the actual input and output modules
configuration user want. For example, set the first input board as DVI module as the following
Select IN|OUT: In, Model:Universal, Signal:DVI, Port:any figure from 1 to 4, click ADD
to
finish.
If the input module is formed by different signal input ports, choose the Model as Typical, it will
allow users to set port type one by one.
X14
User Manual
19
Advertisement
Table of Contents
