Power Supply Connections Of The Controller; Electrical Connection - Festo Checkbox Series Manual

2. Fitting and Installation
2.2

Power supply connections of the controller

2.2.1 Electrical connection

1
Controller X4
2
Conveyor unit
with camera X5
3
Mains cable
Fig. 2/2: Electrical connections of the controller
2-6
Warning
Before carrying out installation and maintenance work
always switch off the power supply. Connect the devices
only when they are switched off.
The power supply for the Checkbox must comply with the
following requirements:
– Voltage range: 85 V to 264 V
– Frequency: 50 Hz/60 Hz
The power unit of the Checkbox automatically recognizes the
voltage applied. Adjustment by hand is not necessary.
Warning
Connect the Checkbox only when it is in faultless condition.
Use only the original connecting cable.
1
2
3
Festo P.BE-Checkbox-EN en 0103c