Suzuki LT80K4 Setup Manual page 30

THROTTLE CABLE
Check the throttle cable play at the throttle lever end.
Throttle cable play: 3.0–5.0 mm (0.12–0.20 in)
If adjustment is necessary, carry out the procedure
below:
1. Loosen the throttle cable adjuster lock nut
B in or out until the correct play.
2. Turn the adjuster
3. Tighten the lock nut
B. Place the rubber boot
#
After the adjustment is completed, check that
handlebar movement does not raise the
engine idle speed and that the throttle grip
returns smoothly and automatically.
TIRE PRESSURE
Using an accurate air gauge, check the air pressure
of the front and rear tires. The pressure should be as
shown.
COLD INFLATION TIRE PRESSURE
FRONT
15 kPa
0.15 kg/cm 2
2.2 psi
Test ride the vehicle checking all mechanical func-
tions. Tighten all nuts, bolts and miscellaneous
mounting parts to the proper torque specs.
Confirm that all cables and wiring harnesses are con-
nected and routed correctly.
IDLE SPEED ADJUSTMENT
After completing all of the servicing procedures and
the test ride, adjust the engine idle speed by turning
the throttle stop screw.
NOTE:
The engine idle should be adjusted with
engine warmed up.
Engine idle speed: 1 450–1 750 r/min
A: Throttle stop screw
29
A.
A while holding the adjuster
C.
REAR
20 kPa
0.20 kg/cm 2
2.9 psi