Advertisement
Available languages
Available languages
SEAT REINSTALLATION
Insert the boss into the guide and seat release lever
into the hole of rear fender with pressing forward,
then press the seat to firmly lock it in place.
A: Boss
B: Guide
C: Lever
D: Hole
TRANSMISSION OIL
!
This vehicle is shipped from factory with the
transmission filled with transmission oil.
Check the transmission oil level.
1. Place the vehicle on the level ground.
2. Remove the oil level screw.
3. If the oil level is below the level hole, remove the oil
filler bolt and add transmission oil into the filler
hole until the oil reaches the level hole and stop
adding just before oil flows out.
NOTE:
Use a good quality SAE 10W-40 multigrade
motor oil.
4. Reinstall the filler bolt and the oil level screw then
tighten it securely.
Transmission oil capacity:
A: Oil level screw
B: Oil filler bolt
BLEEDING AIR FROM THE OIL PUMP CIRCUIT
To bleed the air, hold the motorcycle in standstill con-
dition. Loosen the screw to let out the air and after
making sure that the trapped air has all been bled,
tighten the screw good and hard.
A: Screw
25
80 ml (2.7/2.8 US/Imp oz)
Advertisement
