Suzuki LT80K4 Setup Manual page 10

Properly position the wheels on the axle shaft.
Place the washer and center cap holder on the axle
shaft.
NOTE:
Be sure to install the rear wheels with the air
valves facing outwards.
Install the washer and center cap holder in the
direction as shown in the illustration.
INSIDE
INTERIEUR A: Air valve
B: Axle shaft
C: Center cap holder
D: Washer OD:29.0 mm ID:16.5 mm
Temporarily finger-tighten the axle nut, then remove
the hoist used to lift the vehicle.
NOTE:
Be sure to set the parking brake before tight-
ening the wheels on the axle.
Tighten the rear axle nut to the specified torque.
" Axle nut: 75 N·m (0.75 kgf-m) " " "
A: Parking brake lever
B: Axle nut
WHEEL CENTER CAP
#
Insert the cotter pin through the axle shaft and
bend the ends properly.
Attach the center cap to the wheel.
A: Cotter pin L:47.0 mm
B: Wheel center cap
C: Center cap holder
Lift the front of the vehicle by using hoist.
Remove the wooden block.
9