Suzuki LT80K4 Setup Manual page 12

FRONT BRAKE CAM LEVER
(RIGHT AND LEFT)
Place the washer to the brake cam shaft.
Align and set the brake cam lever's cutting part with
the dent mark on the brake cam shaft's end facing, as
shown in the photograph.
A: Brake cam shaft
B: Washer OD:18.0 mm ID:10.5 mm
C: Brake cam lever
D: Dent mark
E: Cutting part
Install the brake cam lever with bolts and nuts.
Tighten the brake cam lever nuts to the specified
torque.
Set the pin into the brake cam lever, and insert the
end of the brake cable into the pin hole.
Attach the adjuster nut on the end of the brake cable
and have 2 to 3 threads protrude from the adjuster
nut's end facing.
" Brake cam lever nut: 3 N·m (0.3 kgf-m) " " "
A: 5 × 27 mm
"4" marked
flange bolt
B: 5 mm flange nut
C: Brake cam lever
!
Equalize both right and left brake adjustment.
FRONT WHEEL
Carefully wipe the front wheel hubs and drums with a
cloth to remove all dust.
11
D: Pin
E: Brake cable
F: Adjuster nut