Setting The Alarm Clock; Setting The Utc; Setting The Time - Uwatec Meridian Manual

2. Meridian as a watch
2.1.1 Setting the alarm clock
Alarm off
By pressing the SEL/ESC button the alarm
time will start flashing.
You can scroll the hours setting by pressing
+/UP or –/DOWN buttons.
By again pressing the SEL/ESC button the
minutes will start flashing and by pressing
+/UP or –/DOWN buttons you can scroll
them.
By again pressing the SEL/ESC button the
state of alarm will start flashing and 'on' or
'off' can be selected by pressing +/UP or –/
DOWN buttons.
Pressing the SEL/ESC button again at the
end will confirm the alarm time settings.
F
NOTE: Setting the sound setting to
'off' does not affect the alarm clock.
However, the intelligent battery
stretching algorithm disables all
warning tones when there are two
or less dots remaining on the battery
status display or when the battery
symbol is flashing in another display.
2.1.2 Setting the UTC
UTC setting will change the shown time
compared to Greenwich 0-Meridian. This
feature is practical when travelling through
different time zones.
By pressing SEL at UTC menu, the hours
will start to flash. You may edit them with +/
UP or –/DOWN buttons. By pressing SEL
the minutes will start to flash and you may
edit them with +/UP or –/DOWN buttons in
15 minutes increments. Activate the UTC
setting by pressing SEL.
12
2.1.3 Setting the time
Setting the current time
In the display above the current time is
displayed on the menu. By pressing the
SEL/ESC button, the time setting will be
activated: hours start flashing and seconds
will turn to 00. You may change the hours
with +/UP or –/DOWN buttons. By pressing
the SEL/ESC button the selection will
change to minutes and you may now edit
them. By pressing the SEL/ESC the new
time setting will be saved.
F
NOTE: seconds cannot be edited;
they always start counting from 0.
SCUBAPRO MERIDIAN