Using The Stopwatch; Checking The Altitude - Uwatec Meridian Manual

2.1.1 Using the Stopwatch
The first menu from the time of day display
is STOP (watch). By pressing SEL/ESC
button the stopwatch will be activated.
In the first display the stopwatch shows the
status, which can be stop, run or lap. When
activating the stopwatch for the first time
the display will be as shown above.
Press +/UP button and the stopwatch
starts counting showing: run. Press +/UP
button again to stop the counting. The
counted time will stay on the display.
Stopwatch will reset the counted time
when +/UP button is pressed and held.
SCUBAPRO MERIDIAN
2. Meridian as a watch
The laps can be marked by pressing
–/DOWN button when stopwatch is
counting. By doing so the display will freeze
for 5 seconds and Meridian shows the lap
time.
Counting will continue automatically and
the lap counter will show the number of
laps at the bottom of the screen.
By pressing SEL/ESC button you can exit
the stopwatch and return to the stopwatch
menu.
F
NOTE: You can leave the stopwatch
actively counting or you can leave
the stopped time on the display. The
status will be stored in a memory that
allows you to continue from the same
display the next time.
2.1.2 Checking the Altitude
Current Altitude Class
Altitude
On the altitude menu, the current altitude
is calculated from the barometric pressure.
The current altitude, the Altitude Class and
the temperature are shown.
Temperature
17