Selecting The Salt (Ocean) Or Fresh Water; Setting The Backlight On Duration; Setting Audible Attention Signals On And Off - Uwatec Meridian Manual

takes place in dive mode, in the log book,
alarm settings, altitude settings etc.
By pressing SEL/ESC button in this menu
the style of units field value starts to flash.
By the +/UP or –/DOWN button the value
can be changed between meters/feet. By
pressing SEL/ESC button the temperature
field starts to flash. Again by pressing +/-
the value may be changed. By pressing
SEL/ESC button both unit settings will be
confirmed.
3.3.6 Selecting the salt (ocean) or
fresh water
Meridian measures a pressure and converts
depth from it by using the water density as
a constant. 10m/33ft depth at salt water
corresponds approximately to 10.3m/34ft
at fresh water.
By pressing SEL/ESC button at this menu
the on/off field at the bottom row starts to
flash. You may scroll between these two
settings and confirm by pressing SEL/ESC
button.
SCUBAPRO MERIDIAN
3. Meridian as a dive computer
3.3.7 Setting the Backlight on
duration
By pressing SEL/ESC button on this menu
the backlight duration field at bottom row
starts flashing. By pressing the +/UP or
–/DOWN button you may scroll between
user presettable on time from 4 up to 60
seconds.
Status
3.3.8 Setting audible attention
signals on and off
With this option you can switch off the
audible attention signals only (the audible
alarms remain active). By pressing SEL/
ESC button on this menu the on/off field at
the bottom row starts flashing. By pressing
the +/UP or –/DOWN button you may
select between audible attention signals
On or Off. You may confirm the selection by
pressing SEL/ESC button again.
Backlight duration
27