Deactivating The Water Contacts; Apnea Settings; Setting The Dual Depth Alarm - Uwatec Meridian Manual

3. Meridian as a dive computer
3.3.9 Deactivating the water
contacts
If you chose the option "Water contacts
off", Meridian will turn on with a delay of
up to 1 minute into the dive. This will affect
functioning of the dive computer.
Make sure the Meridian is on the surface
mode before starting the dive.
By pressing SEL/ESC button on this menu
the on/off field at the bottom row starts
flashing. By pressing the +/UP or –/DOWN
button you may switch between active or
inactive water contacts. You may confirm
the selection by pressing SEL/ESC button
again.
F
NOTE: With inactive water contact
you prevent Meridian from switching
to dive ready mode when your skin or
surface moisture activates the water
contact.
3.4 APNEA Settings
APNEA diving related selections are
grouped in this menu.
28
Warning
By pressing the SEL/ESC button the
following menu's can be accessed.
3.4.1 Setting the dual depth alarm
With this alarm you can set two
independent depth alarms. By pressing
the SEL/ESC button at this menu the first
depth starts flashing. By pressing the +/UP
or –/DOWN button you may select the first
depth alarm from 5 to 100 meters (20..330
feet). By pressing SEL/ESC the first value
is confirmed and the second alarm starts
flashing. Like the first, by pressing the +/UP
or –/DOWN button the second alarm may
be set from 5 to 100 meters.
First alarm depth Second alarm depth
Status
F
NOTE: The first alarm is short
sequence for attention and the second
alarm is continuous. By setting the first
alarm deeper than the second, it will
SCUBAPRO MERIDIAN