Display Configuration During The Dive - Uwatec Meridian Manual

Table of Contents

Advertisement

Current depth
Max depth
Dive display limits (imperial)
Depth: the depth is given in 10cm resolution 
when  metric  mode.  When  the  depth  is 
displayed in feet, the resolution is always 1 
foot.  At  a  depth  shallower  than  0.8m/3ft, 
the  display  shows  --.  Maximum  possible 
depth is 120m/394ft. 
No-stop  time:  calculated  in  real  time  and 
updated  every  4  seconds.  Maximum 
displayed no-stop times is 99 minutes.
During all dives, perform a safety stop
between 3 and 5 meters/10 and 15 feet for 3
to 5 minutes, even if no decompression stop
is required.
Temperature:  Meridian  displays  the  water 
temperature  during  the  dive  and  the  air 
temperature  on  the  surface.  However, 
the  skin  temperature  influences  the 
measurement when worn at the wrist.
Decompression information: when Meridian 
calculates  the  need  for  a  mandatory 
decompression  stop,  it  shows  you  how 
long and how deep your deepest stop is. It 
also gives you the total ascent time. Stops 
deeper  than  27m/90ft  and  total  ascent 
times  longer  than  99  minutes  are  shown 
as "- - ". 
Decompression information at MB L0: if you 
are  diving  with  an  MB  level  different  than 
MB L0, you can ask Meridian to show you 
the decompression information pertinent to 
the underlying MB L0 calculation. For more 
SCUBAPRO MERIDIAN
Dive time
No-stop time
Warning
3. Meridian as a dive computer
information  on  MB  levels,  please  refer  to 
chapter 3.11.15 diving with Mb levels.
3.6.2
Display configuration during
the dive
Throughout  the  dive,  Meridian  displays 
the  current  depth  (upper  left  corner),  the 
elapsed dive time (upper right corner) and 
the no-stop or decompression information 
(middle row). 
In addition, Meridian utilizes the lower row 
to  display  additional  information  regarding 
the  dive.  By  pressing  +/UP  button  will 
show, in sequence:
1. PDIS depth (when pending)
2. Maximum depth (only if 1m/3ft ascent 
detected)
2. Water temperature
3. Heart rate (if activated)
4. O
 %
2
a. MOD  of  the  active  gas  (if  Gas  d 
enabled)
b. If Gas 1 active then bail out info using 
only Gas 1 at the middle row
c. Active MB level
d. No-stop 
or 
information  at  L0  (displayed  in 
middle row, only if diving with an MB 
level other than L0)
5. CNS % if greater than 1%
6. Time of the day in the middle row 
(temperature at bottom row)
decompression 
33

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Meridian and is the answer not in the manual?

Questions and answers

Table of Contents