Table of Contents
Advertisement
Lockout / Tagout
Lockout / Tagout
Do Not Operate - Accident Prevention Tags
Before beginning any maintenance or service, place a Do Not
Operate Tag on both the starter key switch and the steering
wheel, stating that the telehandler should not be operated.
Do Not Operate Tags, which can be cut out and used, are
included at the end of this manual. Retain these Tags for use
at a later date.
New or Additional Operators
At the time of original purchase, the purchaser of this
telehandler was instructed by the seller on its proper use. If
this telehandler is to be used by an employee or is loaned or
rented to someone other than the purchaser, make certain
that the new operator is trained, in accordance with OSHA
regulations, and reads and understands this Operation &
Safety Manual before operating the telehandler.
In addition, make sure that the new operator has completed
a walk-around inspection of the telehandler, is familiar with
all the labels on the telehandler, and has demonstrated the
correct use of all controls.
Lockout/Tagout Procedure
Perform the following procedure to lockout and tag out the
telehandler. This procedure, requiring a lock, and danger
tags are to be used whenever the telehandler is unsafe for
operation or maintenance.
Removing Telehandler From Service
1.
Attach "DO NOT OPERATE" tags to steering wheel and
ignition key.
2.
Open battery access cover.
3.
Set battery disconnect switch to OFF.
4.
Lock battery disconnect switch.
5.
Attach "DO NOT OPERATE" tag to battery disconnect
switch.
Figure 100. Battery Disconnect Switch
If telehandler is unsafe for operation or maintenance, the
defect or defects must be clearly documented and posted
in a conspicuous place on the telehandler. Failure to comply
could result in death, serious injury, or property damage.
Return Telehandler to Service
When the telehandler has been repaired and made safe for
operation and maintenance, perform the following procedure
to return telehandler to service.
1.
Remove lock and "DO NOT OPERATE" tag from battery
disconnect switch.
2.
Close battery access cover.
3.
Remove "DO NOT OPERATE" tags from steering wheel and
ignition key.
Figure 101. DO NOT OPERATE Tag
75
Warning
Operation Manual
Operation Manual
Advertisement
Table of Contents
