Table of Contents
Advertisement
Operator Cab
Load Capacity Charts
The Load Capacity Charts are located on the left side of the
front control panel (Figure 27 - C) and are provided to assist
the operator in determining how to safely handle loads with
the telehandler, including boom angle, height, and reach.
Display Indicators
The display allows the operator to view vital engine information
and other critical functions, including gauge display, engine
diagnostics to monitor engine condition and performance,
rear camera video, fault codes, and warning indicators. Refer
to the Operation section on Warning Indicators and the
Engine Indicator Chart (Fig. 64).
A. HIGH HYDRAULIC OIL TEMP
The hydraulic oil temperature indicator illuminates when the
oil temperature is above 1800 F (820 C). If the hydraulic oil
temperature indicator illuminates, stop and idle the engine
to allow time for cooling. If the hydraulic oil temperature
indicator does not go out after five (5) minutes, stop the
telehandler, follow proper shut down procedures, tag the
telehandler with "Do Not Operate" tags, and have a qualified
service or repair BEFORE placing it into service again.
A
X
H
I
L
Figure 28. Display Indicators - Main Menu With All Indicators Active
C
B
J
K
M
B. WATER IN FUEL
The Water in Fuel Indicator is displayed when water is detected
in the fuel filter. Drain the water by opening the petcock on
the bottom of the fuel filter.
C. LOW BRAKE PRESSURE
The Low Brake Pressure indicator is displayed if the hydraulic
oil pressure gets too low. If the Low Brake Pressure indicator
is illuminated, do not release the parking brake or engage
transmission until the indicator is out. If the indicator does
not go out, stop the telehandler, follow proper shut down
procedures, tag telehandler with "Do Not Operate" tags, and
have a qualified mechanic service or repair the telehandler
BEFORE placing it into service again.
D. LOW OIL PRESSURE
The Low Oil Pressure Indicator is displayed when the engine
oil pressure is below normal (10 psi or lower). If the Oil Pres-
sure Indicator comes on during normal operation, stop the
telehandler, follow proper shut down procedures, tag telehan-
dler with "Do Not Operate" tags, and have a qualified service
or repair the telehandler BEFORE placing it into service again.
E. WAIT TO START
The Wait to Start Indicator is displayed when the key switch is
moved to the RUN position. Wait until the indicator goes out
before starting the engine.
D
E
G
N
O
P
R
S
37
F
Q
X
Operation Manual
Operation Manual
X
T
U
V
W
Advertisement
Table of Contents
