Table of Contents
Advertisement
1
A
2
Figure 52. Attachment Tilt Control Thumbstick (A)
(1) Attachment Tilt Down (2) Attachment Tilt Up
Auxiliary Attachment Control
Frame Sway Control
The Frame Sway Y-Handle is used to enable the machine frame
sway before lifting any loads. For this purpose, the Y-Handle is
moved sideways, left or right as needed to level the telehan-
dler before lifting any weight.
Figure 53. Frame Sway Y-Handle
Function
Frame sway right Move Y-Handle right
Frame sway left
Move Y-Handle left
Operation Manual
Operation Manual
F R O N T
OF
VEHICLE
Action
NOTE: Lock the frame sway by placing the travel select lever
in NEUTRAL or applying the service or parking brake.
NOTE: Maximum frame sway is 220 overall or 110 each
direction, left and right.
Boom Maintenance Stand (If Equipped)
The Boom Maintenance Stand is an optional safety equip-
ment used to support the boom during any and maintenance
activities where the boom is raised.
When preparing to set boom stand:
•
Make sure machine is on a flat level ground and machine
has no load on the forks.
•
Raise machine boom to 40 degrees for clearance and re-
move latch and pin from boom stand weldment.
•
Position the boom stand in the upright position and
re-apply the pin to secure stand.
•
Proceed by slowly lowering machine boom to lay on
stand.
When not in use, fold the support down and latch it in place.
When preparing to remove boom stand:
•
Make sure all maintenance has been performed and area
is clean.
•
Raise machine boom to 40 degrees for clearance and re-
move pin from stand weldment
•
Lay boom stand in the down position and re-latch stand
to secure.
44
Operator Cab
Advertisement
Table of Contents
