Table of Contents
Advertisement
Operation
5.
Tilt the attachment up slightly. The quick attach adapter
should be tight against the rear of the attachment. Align
the holes between the quick attach adapter (C) and
attachment (B).
B
Figure 79. Tilt Attachment To Align Holes (B) and (C) Between Attachment
and Quick Attach Adapter.
6.
Raise the quick attach lock lever.
7.
With lock lever raised, insert quick attach pin completely
through the attachment and quick attach adapter.
Figure 80. Quick Attach Lock Lever.
C
63
Figure 81. Insert Quick Attach Pin Through Attachment and Quick Attach
Adapter.
8.
Release the quick attach lock lever and make sure it has
lowered and seated itself in groove (A) of quick attach pin.
Figure 82. Quick Attach Lock Lever and Quick Attach Pin.
9.
Connect the quick attach couplers (this only applies to
attachments with a quick attach hydraulic system).
Hydraulic attachments have a maximum
hydraulic pressure rating. Failure to make
sure the attachment is equipped with a
pressure reducing valve, or is rated to be
equal or greater than 3,900 psi, which is the
maximum pressure of the telehandler auxiliary hydraulic
system at the quick-disconnect couplers, could result in
death or serious injury.
Warning
Operation Manual
Operation Manual
Advertisement
Table of Contents
