Table of Contents
Advertisement
•
Adjust the load as necessary, especially for nonstandard
loads.
•
Use caution when handling loose material that can fall
into the cab.
•
Remove overhanging load materials, when possible,
and watch for sliding material.
•
DO NOT reach a load over posts or other objects that
can enter the cab, if tipped.
•
Avoid sudden stops, starts, or turns.
•
Avoid carrying a swinging load. If necessary, secure the
load by attaching it to the telehandler tie-downs and/
or have another person assist with safely steadying the
load.
Boom Lift Point
DO NOT exceed rated capacities. Any attempt
to lift or carry loads in excess of those shown
on the load capacity charts could cause
telehandler tip over, loss of load, or structural
damage which could result in death, serious
injury, or property damage.
There is a boom lift point on the underside of the boom that
may be used to lift and carry loads.
There is a dedicated boom lift point load chart on the
telehandler, which should be referenced when using the
boom lift point. Refer to the suspended loads section of this
manual when handling suspended loads for specific warnings
and instructions unique to this type of operation.
Figure 88. Boom Lift Point
Operation Manual
Operation Manual
Warning
Suspended Loads
Avoid carrying a suspended load. If necessary,
secure the load by attaching it to the
telehandler tie-downs and/or have another
person assist with safely steadying the
load. The handling of suspended loads can
introduce dynamic forces drastically affecting the stability
of the telehandler. Grades and sudden starts, stops, and
turns can cause the load to swing and create a hazard if not
stabilized. Swinging loads can become unstable, and could
cause death, serious injury, or property damage.
1.
Do not exceed the load capacity of the telehandler (as
noted on the load chart).
2.
Only lift the load vertically, and never drag it horizontally.
3.
Transport the load with the bottom of the load and the
boom as low as possible.
4.
With the load elevated, move the telehandler slowly
and cautiously. Only move the telehandler to the extent
needed to raise, transport, and place the load.
5.
Use guy lines to restrain load swing if possible.
Pick Up A Load
1.
Use correct load chart to review the rated load capacity of
the auxiliary attachment being used. NEVER exceed spec-
ified weights and load centers.
2.
Approach the load slowly and squarely with the fork tips
straight and level.
3.
Adjust the spacing of the forks so they engage the pallet
or load at its maximum width. NEVER use just one fork to
lift a load.
4.
Insert forks under the load until the load is against the
fork frame. Load should be supported in such a manner
that the forks can be positioned in a resistance free man-
ner.
5.
Insert forks under the load until the load is against the
fork frame.
6.
Tilt the forks back, and raise the boom slightly to secure
the load.
Carry A Load
1.
Carry the load as low as possible while maintaining good
ground clearance and visibility.
2.
Back away slowly.
3.
To travel with a load, use first gear (1) for highest torque
and pulling power. NEVER travel in higher gears when
carrying a load.
66
Operation
Advertisement
Table of Contents
