Table of Contents
Advertisement
Lockout / Tagout
Do Not Operate - Accident Prevention Tags
Before beginning any maintenance or service, place a Do Not
Operate Tag on both the starter key switch and the steering
wheel, stating that the forklift should not be operated. Do Not
Operate Tags, which can be cut out and used, are included at
the end of this manual. Retain these Tags for use at a later
date.
New or Additional Operators
At the time of original purchase, the purchaser of this forklift
was instructed by the seller on its proper use. If this forklift is
to be used by an employee or is loaned or rented to someone
other than the purchaser, make certain that the new operator
is trained, in accordance with OSHA regulations, and reads and
understands this Operation & Safety Manual before operating
the forklift.
In addition, make sure that the new operator has completed
a walk-around inspection of the forklift, is familiar with all the
labels on the forklift, and has demonstrated the correct use of
all controls.
Lockout/Tagout Procedure
Perform the following procedure to lockout and tag out the
forklift. This procedure, requiring a lock, and danger tags are
to be used whenever the forklift is unsafe for operation or
maintenance.
Removing Forklift From Service
1.
Attach "DO NOT OPERATE" tags to steering wheel and
ignition key.
2.
Open battery access cover.
3.
Set battery disconnect switch to OFF.
4.
Lock battery disconnect switch.
5.
Attach "DO NOT OPERATE" tag to battery disconnect
switch.
Operation Manual
Figure 95. Battery Disconnect Switch
If forklift is unsafe for operation or maintenance, the defect
or defects must be clearly documented and posted in a
conspicuous place on the forklift. Failure to comply could
result in death, serious injury, or property damage.
Return Forklift to Service
When the forklift has been repaired and made safe for
operation and maintenance, perform the following procedure
to return forklift to service.
1.
Remove lock and "DO NOT OPERATE" tag from battery
disconnect switch.
2.
Close battery access cover.
3.
Remove "DO NOT OPERATE" tags from steering wheel and
ignition key.
Figure 96. DO NOT OPERATE Tag
74
Lockout / Tagout
Warning
Hide quick links:
Advertisement
Table of Contents
