Table of Contents
Advertisement
Engine Protection System
The engine is equipped with an engine protection system. The
system monitors critical engine temperatures and pressures,
and logs diagnostic faults when an over or under normal con-
dition occurs. If an out-of-range condition exists and engine
derate action is to be initiated, the operator is alerted by an
in-cab WARNING lamp.
The STOP ENGINE Indicator blinks or flashes when out-of-
range conditions continue to worsen. The driver must pull to
the side of the road or to a safe area when it is safe to do so, to
reduce the possibility of engine damage.
NOTE: Engine power and speed will gradually be reduced,
depending on the level of severity of the observed condition.
The engine protection system will not shut down the engine
unless the engine protection shutdown feature has been
enabled.
Pintle Hook
Death or serious injury could result from im-
proper operation when using tow connection.
Do not elevate boom above 30 degrees when
towing. Do not exceed rated tow capacity
(500 lbs vertical load, 5,000 lbs tow capacity.
The Pintle Hook is used for towing trailers and equipment, rat-
ed at or below 5,000 lbs maximum capacity. Failure to comply
with this capacity limitation, or elevating the boom above 30
degrees when towing could result in death or serious injury.
Figure 72. Pintle Hook
Operation Manual
Operation Manual
Attachments
Attachment Disclaimer
DO NOT exceed the manufacturer's rated
load for any auxiliary attachment.
attempt to lift or carry loads in excess of
the manufacturer's rated load may cause
telehandler tip over, loss of load, or structural
damage which could result in death, serious injury, or
property damage.
Xtreme Manufacturing makes no representations or warranties,
expressed or implied, as to the design, manufacture, or fitness
for use with this telehandler of any third party attachment. This
telehandler is not intended to be used and should not be used
with an attachment that would alter the center of gravity or
stability of this telehandler. Xtreme Manufacturing assumes
no liability for any third party attachment that would alter the
center of gravity or stability.
Fork Ratings
DO NOT exceed telehandler capacity of 15,000
pounds. The total rated capacity of the forks
being used must equal or exceed telehandler
capacity. Forks can break causing loss of load
and could result in death or serious injury.
All approved forks for this telehandler are marked with a
maximum load capacity rating (A). This rating is stamped on
the left edge of the fork just below the fork pivot shaft. The
rating listed is in U.S. pounds and is based upon a 24 inch load
center (B). This rating specifies the maximum load capacity
that the individual fork can safely carry at a maximum load
center of 24 inches.
Because forks are always used in multiples, the total rating
of any combination of forks will be the sum of their rated
capacity. Other than block forks, all forks should be used in
matched pairs. Block forks should be used in matched sets.
The maximum load capacity for this telehandler is 15,000
lbs. The matched pair or set of forks used on this telehandler
should have total load ratings which equal or exceed 15,000
lbs. When the load rating of the telehandler differs from the
load capacity of the forks, the lower value becomes the overall
load capacity.
60
Operation
Warning
Warning
Any
Advertisement
Table of Contents
