Dispensing Multiplicator Products; Multiple Dispensing Of A Single Product; Batch Mode - Melitta Cafina XT5 Operating Instructions Manual

6�7

Dispensing multiplicator products

Under product settings (see chapter 7.6 on page 23),
you can set up products as multiplicator products. This
means that you can issue multiple portions of a product
in succession if necessary, for example to fill a larger cup.
Note
In order to dispense a multiplicator product,
there must be enough product material and
capacity in the coffee grounds drawer.
1. Position a cup underneath the beverage outlet.
2. Press the corresponding product button on the
display.
͵ While the product is being dispensed, the display
shows how many single products are included in
the multiplicator product and which single prod-
uct is currently being dispensed (e.g., "1 / 4", the
first product of four single products).
͵ The products are prepared and dispensed in suc-
cession.
9 The dispensing of the multiplicator product is
complete.
6
6�8

Multiple dispensing of a single product

Multiple portions of a product can be requested as
necessary and dispensed directly in sequence. The
advantage of multiple dispensing is that you do not need
to select the product again for every subsequent portion.
1. Position a cup underneath the beverage outlet.
2. Press the corresponding product button on the
display.
3. While the product is being dispensed, press the
"Repeat" button several times in succession
depending on the number of additional portions that
you would like to dispense.
͵ The products are prepared and dispensed in suc-
cession.
4. Once a portion has been dispensed, put the cup
to one side and place another cup underneath the
beverage outlet.
9 The multiple dispensing operation is complete.
Dispensing products
18
6�9

Batch mode

Batch mode can be used to preselect multiple products
and dispense them in sequence.
Café Crème Latte Macchiato
Espresso Ristretto
*** ***
Steam Cappuccino
Milk foam
Hot water
cold
PRODUCT
SELECTION FILTER
Depending on the preset in the manager menu (see
chapter 7.1 on page 20), the batch mode (1) can be
switched on and off by default.
To switch the batch mode itself on or off, press the bar for
the batch mode (1) on the right of the display.
Product dispensing in batch mode
1. With batch mode switched on, press the products to
be dispensed in sequence.
2. Press the "" (3) button in the display to start dis-
pensing the first product.
3. Once a product has been dispensed from the batch,
remove it and position a suitable container for
the next product underneath the corresponding
beverage outlet.
Cappuccino
**
Pre-set batch input
PRODUCT
SELECTION FILTER
Café Crème
Cappuccino
**
Espresso
***
1
2
3
UNIT
Fig. 23: Batch mode
Cappuccino
**
Espresso
***
1
2
UNIT
Fig. 24: Product dispensing
30997 • 20160401