00
BEFORE INSTALLATION
A) Read entire installation instructions before proceeding.
B) Be careful not to damage paint or kit components.
C) Do not over tighten bolts, tighten to specified torque.
D) Clean mud, dirt and salt from installation areas.
E) Some steps of this installation will require two people to complete.
01
REMOVE PLASTIC UNDERBODY ASSEMBLY
TOOLS: FLATHEAD SCREWDRIVER, RATCHET, M10 SOCKET
A) Remove two plastic fasteners with a flathead screwdriver.
B) Remove two nuts and discard.
C) Pull plastic panel down and discard.
02
TRIM BUMPER FASCIA
TOOLS: TRIM TEMPLATE, TAPE, SAW, FILE
A) Clean any dirt and salt from trim area.
B) See notes on trim template for proper template selection. Check
to ensure template (ITEM J) is printed to scale using top left corner.
C) Cut out template around outside border.
D) Use plastic fasteners removed in step 1A to locate template and tape into position.
E) Use saw to cut rear fascia on 'TOW HITCH CUTTING LINE'.
F) Use file to remove rough edges.
G) Remove plastic fasteners which were installed to hold the trim template and discard.
02/24/2016
2 of 8
10MM
0000-8E-N31
Rev G