Advertisement
2．BEFORE INSTALLATION
REQUIRED TOOLS
☆Screwdriver (Phillips)
WARNING
• Park the vehicle on a flat, level surface, set the selector lever to P (AT vehicles), apply the parking brake and
block the wheels so that the vehicle does not move during installation.
CAUTION
Use the most appropriate
(size, use) tool for each task and
perform the may be damaged.
CAUTION
• Always use a torque wrench when tightening bolts and tighten to the specified torque. If tightened outside
the specified torque, it could result in poor fit, part damage, or other damage.
• The mud flap (Rear) is made of hard plastic. Handle it with care, as it may be deformed or discolored if it
contacts solvents such as paint thinner or comes close to flame.
NOTE
• Refer to the applicable Workshop Manual for removal and installation of vehicle parts. Not following the
procedures for removal/installation in the Workshop Manual could result in an accident or vehicle
malfunction.
☆Torque wrench
Place the removed parts and kit
accessories on a protective sheet
to prevent scratches.
☆Nipper
☆Jack
3
☆Protective sheet
Advertisement
