Advertisement
3. BEFORE INSTALLATION
REQUIRED TOOLS
Phillips screwdriver
Fastener remover wrapped with protective tape
WARNING
Before performing any work,
park the vehicle on level
ground, apply the parking
brake securely, and then block
the wheels. If the vehicle
moves while performing work,
it may cause injury.
CAUTION
Be sure to cover the vehicle
body with protectors or mats
to prevent stains, scratches
and damage when removing/
installing the vehicle parts.
Make sure to remove burrs.
If any burrs remain,
deformation will occur.
Advice
Refer to the Workshop Manual
for removal and installation of
vehicle parts. If the procedures
in the workshop manual
are not followed, operating
problems or accidents may
result.
WORKSHOP
MANUAL
(Make sure they are at hand before starting work)
Using improper tools may
cause damage and or broken
parts. Use the correct tool for
the installation.
Socket wrench (8mm)
Utility knife
Wrap protective tape around
screwdrivers and fastener
remover tools to prevent
scratching the vehicle.
3
Nipper
Burr remover
Put the removed parts and
the parts in the kit on the
protective sheet to prevent
scratches.
Advertisement
