Table of Contents
Advertisement
Assign a hardware port to the name by turning the course knob
until the hardware port is displayed along with the name.
Proceed to the names on the list that shall be assigned by
pressing STBD [>] button. Select appropriate hardware ports by
turning the course knob, or exit from menu by stepping through
the list of names by pushing STBD [>] button.
At the completion of the Interface Setup, the names of items that
Note !
you have assigned hardware ports to will be available as
sources of data for NAV (navigation), POS (position) and
COMPASS in the USER SETUP MENU. It is recommended that
you access the User Setup Menu directly after completing the
Interface Setup to select the desired data. Refer to page 31 for
details on changing the items in the User Setup Menu.
The standard NMEA output rate is 1x/second. When Output
Note !
INSTR is set to J300X-1 (default), the output port, TX1, will have
an output rate of 5x/sec. for HDM or HDT (heading) messages.
The output rate may be changed to 1x/second by rotating the
course knob. The RSA (rudder angle) message is always 5x/sec.
20220505H
INSTR: J300X-1
RADAR: ANRITSU
Abbreviated
Assigned
name
HW port
Installation
5/sec
Output:
5/sec
1/sec
NMEA output
rate
95
Advertisement
Table of Contents
