Attaching The Eyepieces (Whb10X, Whb10X-H); Attaching The Eyepiece Micrometer - Olympus CX43 Instructions Manual

3

Attaching the eyepieces (WHB10X, WHB10X-H)

a
b
4

Attaching the eyepiece micrometer

The eyepiece micrometer can be attached only to the eyepieces (C3X-10X/18-H, C3X-10X/18) provided with the tilting
TIP
binocular tube (U-CTBI). The size of the eyepiece micrometer which can be attached to eyepieces of this product is
20.4mm in diameter and 1.0mm in thickness.
1
5
1
1
2
3
1 1
a
2
3
NOTE
4
c
NOTE
3
4 5
b
Remove the eyepiece cap.
Insert the eyepiece a into the eyepiece sleeve b until it touches
the end.
Tighten the eyepieces clamping screw provided with the microscope
frame using the small flathead screwdriver to fix the eyepieces.
To attach the eyepiece micrometer, loosen the clamping screw a of
the right side eyepiece using a small flathead screwdriver and remove
the eyepiece.
Hold the eyepiece frame, loosen the reticle holder b and remove
the reticle holder b .
Insert the eyepiece micrometer c in the removed reticle holder b
with the display surface of the micrometer facing down.
Be careful not to leave dirt on the eyepiece micrometer c ,
since it will be noticeable during observation.
Screw in the reticle holder b which includes the eyepiece micrometer
c to the bottom of the eyepiece gently.
Be sure to screw in the reticle holder b completely until
it stops.
Attach the eyepieces to the tube, and tighten the clamping screws a .
CX43
39