Attaching And Removing The Enclosure Bezel; Attaching The Enclosure Bezel; Removing The Enclosure Bezel; Partial Assembly Showing Bezel Alignment (2U24) - Lenovo D1012 Hardware Installation And Maintenance Manual

Attaching and removing the enclosure bezel

Before accessing front panel LEDs, you must first remove the enclosure bezel.
Ball stud on chassis ear
(typical 4 places)

Attaching the enclosure bezel

1. Orient the bezel to align its back side with the front face of the enclosure as shown in the figures above.
2. Face the front of the enclosure, and while supporting the base of the bezel, position it such that the
mounting sleeves within the integrated ear caps align with the ball studs.
3. Gently push-fit the bezel onto the ball studs to attach the bezel to the front of the enclosure.

Removing the enclosure bezel

1. While facing the front of the enclosure, insert the index finger of each hand into the top of the
respective (left or right) pocket opening shown in the figures above.
2. Insert the middle finger of each hand into the bottom of the respective opening, with thumbs on the
bottom of the bezel face.
3. Gently pull the top of the bezel while applying slight inward pressure below, to release the bezel from
the ball studs.
42
Figure 25 Partial assembly showing bezel alignment (2U24)
Enclosure bezel sub-assembly
(EMI shield and removable air filter)
Figure 26 Partial assembly showing bezel alignment (2U12)
Enclosure bezel sub-assembly
Pocket opening (typical 2 places)
Ball stud on chassis ear
(typical 4 places)
Pocket opening (typical 2 places)