Table of Contents
Advertisement
Disk drive
module
Enclosure bezel for 12-drive model
The LFF 12-Storage Enclosure supports a bezel sub-assembly that attaches to the front of the chassis. The
bezel—comprised of a vented cover attached to an EMI (Electromagnetic Interference) shield—is
pre-assembled.
Enclosure bezel sub-assembly
(EMI shield and removable air filter)
NOTE: For additional information, contact support.lenovo.com, select Product Support, and navigate to
Storage Products.
NOTE: The enclosure bezel geometry shown in illustrations within this document may be slightly different
than the bezel shipped with your product, but the ball stud attachment points are the same.
See
Attaching and removing the enclosure bezel
Figure 23 Enclosure architecture — internal components sub-assembly (2U12)
Figure 24 Partial assembly showing bezel alignment (2U12)
Pocket opening (typical 2 places)
on page 42 for more information.
D1012/D1024 Hardware Installation and Maintenance Guide
Power supply unit
ESM
Midplane
Ball stud on chassis ear
(typical 4 places)
39
Advertisement
Table of Contents
