opening, with thumbs on the bottom of the bezel face. Gently pull the top of the bezel while applying slight
inward pressure below, to release the bezel from the ball studs.
Ball stud on chassis ear
(typical 4 places)
Figure 7 Partial assembly showing bezel alignment with 2U24 chassis
Enclosure bezel sub-assembly
(EMI shield and removable air filter)
Figure 8 Partial assembly showing bezel alignment with 2U12 chassis
NOTE: The dual-purpose 2U24 and 2U12 enclosure front panel illustrations that follow assume that you
have removed the enclosure bezel to reveal underlying components.
Pocket opening (typical 2 places)
Pocket opening (typical 2 places)
D1012/D1024 Hardware Installation and Maintenance Guide
Enclosure bezel
Ball stud on chassis ear
(typical 4 places)
19