Table of Contents
Advertisement
Step 2.
Press the tab on the outer edge of the control panel assembly to release the assembly from the
inside of the bezel.
If you are instructed to return the control panel assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Continue to "Replacing the control panel assembly" on page 34.
Replacing the control panel assembly
Use these instructions to install a replacement control panel assembly in the storage expansion node.
Before you install the control panel assembly, read "Safety" on page iii and "Installation guidelines" on
page 25.
To install the control panel assembly, complete the following steps.
Attention: Make sure that the drive drawer is supported when it is open. The weight of installed drives can
cause the storage expansion node assembly to be unstable when the drive drawer is open.
Step 1.
With the drive drawer open approximately 20 cm (8 in.), insert the tab on the end of the control
panel assembly into the slot on the inside of the bezel; then, press the other end of the assembly
until it snaps into place. You might have to use a flashlight to see the slot on the inside of the bezel.
Step 2.
Connect the control panel assembly cable to the connector on the drawer. The connector is
keyed to prevent incorrect connection.
After you install the control panel assembly, complete the following steps:
1. Close the drive drawer.
2. Install the cover on the storage expansion node.
3. Install the storage expansion node assembly into the chassis. See "Installing the storage expansion
node in an Flex System Enterprise Chassis" on page 14 for instructions.
Removing the bezel
Use these instructions to remove the bezel from the storage expansion node.
34
Flex System Storage Expansion Node Installation and Service Guide
Advertisement
Table of Contents
