Table of Contents
Advertisement
2
3
1
Cam handle
1
Fan module
2
Cam handle release latch
3
Fan module Attention LED
4
Step 4.
Pull the fan module straight out from the chassis, making sure that you support it with your free
hand so that it does not swing out of the chassis.
CAUTION:
The fan modules are short. Always support the bottom of the fan module with your free hand
so that it does not suddenly drop free from the chassis and injure you.
Step 5.
Set the fan module aside.
Step 6.
Repeat the preceding steps for any remaining fan modules.
Step 7.
Insert the fan module into the replacement chassis by aligning it with the opening, and then sliding
it into the chassis.
Step 8.
Push firmly on the fan module cam handle so that it is seated all the way into the chassis.
The cam handle raises slightly when the fan module is completely seated.
Step 9.
Swing the cam handle up to its closed position, making sure that the cam handle release latch
clicks into the locked position.
Step 10. Repeat these steps for the remaining fan modules.
Step 11. Align the bezel with the ball studs, and then gently push the bezel onto the ball studs.
Removing the controller module
To replace the chassis, you must remove the controller module or modules from the old chassis.
About this task
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-CZwRXsocAOmi5RsaXDVZQG
ThinkSystem DM7000x Hardware Installation and Maintenance Guide
80
4
Advertisement
Table of Contents
