Advertisement
Figure 36
1. Left headlight
2. Flanged-head bolts (1/4 x
5/8 inch)
4. Align the holes in the tank-support bracket with the
holes in the lower headlight support
Figure 37
1. Flanged-head bolts (1/4 x
5/8 inch)
2. Hole (tank-support
bracket—MD-series
models)
5. Assemble the tank-support bracket to the lower
headlight support with 2 flanged-head bolts (1/4 x 5/8
inch) that you removed in step
6. Torque the 2 bolts to 79 to 147 N∙cm (7 to 13 in-lb).
3. Lower headlight support
4. Front of the machine
(Figure
37).
3. Holes (lower headlight
support and left fender
liner)
3 (Figure
37).
Connecting the Hose to the Wiper
1. At the overhead console, route 1 end of the hose (3/16
inch) through the hole in the overhead console
38)
1. Hole (overhead console)
2. Bulb seal
3. Hose (3/16 inch)
2. Insert the small end of the barbed hose fitting into the
end of the hose from the wiper arm until the fitting
fully seats
(Figure
3. Insert the large end of the barbed hose fitting to the
end of the hose (3/16 inch) until the fitting fully seats
(Figure
38).
Routing the Hose
1. Route the hose (3/16 inch) to the left of the overhead
console along the bulb seal at the front of the cab
frame
(Figure
39).
1. Hose (3/16 inch)
2. Hole (overhead console)
3. Bulb seal
2. Route the free end of the hose into the opening at
the top of pillar A (driver's side) of the cab frame and
13
Figure 38
4. Barbed hose fitting
5. Hose (wiper arm)
38).
Figure 39
4. Pillar A (driver's side)
5. Front of the machine
(Figure
Advertisement
