Advertisement
Connecting the Wire Harness at the
Overhead Console
1. At the overhead console, route the 2-pin connector
end of the wire harness for the washer pump through
the hole in the overhead console
Figure 43
1. Hole (overhead console)
2. 2-socket connector (cab
wire harness)
2. Align the 2-pin connector of the washer pump wire
harness to the 2-socket connector of the cab wire
harness
(Figure
43).
3. Push the 2 connectors together until the connector
secures
(Figure
43).
4. Route the 2-socket connector of the wire harness for
the washer pump to the left of the overhead console
along the bulb seal at the front of the cab frame
43).
(Figure
43).
3. Washer pump wire
harness
4. 2-pin connector (washer
pump wire harness)
(Figure
Routing the Wire Harness
1. At the overhead console, route the wire harness for the
washer pump
(Figure
the hose installed in
1. Overhead console
2. Washer pump wire
harness
2. Route the 2-socket connector of the wire harness into
the opening at the top of pillar A (driver's side) of the
cab frame and down to the hole at the bottom of the
pillar
(Figure
45).
Note: Use a stiff piece of wire, about 130 cm (51
inch) long, to pull the wire harness through pillar A of
the cab frame.
15
44) to the left and along side of
Routing the Hose (page
Figure 44
3. Pillar A (driver's side)
13).
Advertisement
